Rudder trim display.

Pedestal panels are slowly getting connected one by one and so I came to panel 110VU Rudder trim, Parking brake. I got this panel without rudder trim display but later got one from A330. Display is no exactly the same
HOME COCKPIT from DIY to OEM
Pedestal panels are slowly getting connected one by one and so I came to panel 110VU Rudder trim, Parking brake. I got this panel without rudder trim display but later got one from A330. Display is no exactly the same
I started working on Electric panel 35VU pin-out and it is a nightmare. Korry OFF lights are all connected in a group and they all use same two pins which is logical I guess. I need to find a way
Flaps panels usually come without transducers or command sensor unit (CSU) as Airbus calls it! In the CSU unit there are four 5-track switches for sending the flap detent position signals. Even without CSU there is still a control lever mechanism
Pedestal is slowly coming together, not all panels are interfaced yet but I managed to wire all back-light pins. All wires come to the front and are connected in connector strip. I think the picture says it all. These lights
My pedestal came without throttle transducers and it’s usually like that. Therefore I was thinking what could be the easiest way to interface throttle and finally found a solution. I noticed that the TCU has an accessible mechanical-detent axis which I could use. I
Some time I get lucky and find these rare parts like this old type ECAM panel. It looks terribly worn out but that brings the price down which is good. First I started with refurbishment by removing what was left of
I wanted Transponder/TCAS panel interfaced but again it was one of the ARINC bus panels that I can’t interface as they come! I guess you know what method followed… Got this panel in AR condition so it felt bad gutting
Got this Audio control panel from a friend as it was tagged as beyond repair with extra a sticker saying “for scrap”. Ok, to be honest I didn’t even inspect how this panel works. I immediately opened the panel and started studying internal connections. Of
Radio management panel or shorter RMP is one of those panels with their own electronics meaning it uses ARINC bus to communicate. Making it work directly is basically beyond my current knowledge. I was thinking if maybe Arduino controller board
I wanted to see how the front windscreen columns fits the glare and for that I also wanted to position and test fit the overhead rack frame. I made provisional wooden beam support and used middle and back frame hanging points
Recent Comments